Jameco Electronics Superpro Series User Manual

Page 15

Advertising
background image


Figure 15. Run

Program
The function writes the data from the buffer into the chip. The Verify function is
performed automatically after programming. If an error occurs, the error message will be
displayed along with the addresses and data of the chip and buffer where the error
occurred. Any other result will be displayed in the message section. The current address
is incremented in the Current Address display window while the chip is being
programmed or verified.

Read
The function reads the content of the chip into the buffer. After reading is complete,
checksum of the data will be displayed at the lower-left corner of the screen. If the chip
selected is either a PLD or GAL, blow count will be shown instead of the checksum.
When a GAL is programmed, the sub-device should be specified correctly.

For PROM or MCU devices, the data between the chip start address and end address will
be read into the buffer.

If the chip is protected or secured, data read will be incorrect or shown as blank.

Advertising