Jameco Electronics Superpro Series - Manual (Page 19)

The Word Format window allows you to specify the data format loaded into the buffer.
The default setting is Byte format. Word or Double Word format may be selected. For
programming into byte- wide chip further selection to byte level is needed.
Byte
8-bit data format is selected.
Even Word
In the 16 bit word format, selection of Even Word will program only the even data bytes
For example, if the data is;
buffer address
00 01 02 03 04 05 06
buffer data 01 23 45 67 89 AB CD
Result after programming will be;
device address
00 01 02 03 …
device data 01 45 89 CD …
Odd Word
In the 16 bit word format, selection of Odd Word will program only the odd data bytes
For example, if the data is;
buffer address
00 01 02 03 04 05 06
buffer data 01 23 45 67 89 AB CD
Result after programming will be;
device address
00 01 02 03 …
device data 23 67 AB …
In the Double Word format, there are four bytes to be selected from
For example,
buffer address 00 01 02 03 04 05 06 07 08 09 0A 0B
buffer data
01 23 45 67 89 AB CD EF FE DC BA 98
Double Word 0 selection will process the data at addresses 00, 04, 08,.. for reading,
verifying, and programming, which are 01 89 FE.
Double Word 1selection will process the data at locations 01, 05, 09,..which are 23,
AB, DC.
Double Word 2 selection will process the data at locations 02, 06, 0A,.. which are 45,
CD, BA,..
Double Word 3 selection will process the data at addresses 03, 07, 0B, which are 67 EF
98.