Jameco Electronics Superpro Series - Manual (Page 7)

Up arrow key = <Up arrow>
Down arrow key = <Down arrow>
Unless stated otherwise, keystrokes are not case-sensitive. e.g.: Both 'A' and 'a' are
acceptable.
1.3.2 System Requirements
The minimum requirement is as follows:
1. A 486 or Pentium PC, desktop or laptop.
2. One parallel port, such as LPT1 (278H), LPT2 (378H), or LPT3 (3BCH).
3. MS Windows9x, NT or 2000 operating system (model dependant)
4. Diskette drive (3.5" 1.44 Mbytes) or CD-ROM for installation
5. Hard disk storage of at least 10 Mbytes of spare capacity.
6. Color graphic adaptor and monitor.
1.1.5
Programmer Package
Standard package contains the following:
6. A programmer module
7. A parallel connecting cable
8. A dual range switching power supply (model dependant)
9. An installation software diskette (3 1/2") or a CD-ROM
1.2 System Setup
1.2.1 Software Setup
Insert the setup disc or CD-ROM into a drive and run SETUP.EXE. At the beginning of
setup, default folder will be created or you may create/select the folder of your choice.
Setup program creates three sub-folders, BIN, LIB and ALGO. The main program and
configuration files are stored in the Bin folder, the device library files are stored in the
LIB folder, and the programming algorithm files are stored in the ALGO folder. There are
many hundred device programming algorithm files stored in the ALGO folder and less
than 100 files stored in the LIB folder. BIN folder contains the main program. When the
program is run, system operating configuration file is created and stored in the BIN
folder.
When the program is set up but doesn’t run properly, please check the folders and see if
the files are expanded and stored properly.
1.2.2 Hardware Setup
Connect the programmer module to the computer's printer (parallel) port with the cable
provided. Then, connect the power supply adapter and turn on the programmer power