JVC CH-X100 - Manual (Page 11)

11
ENGLISH
Playing the current tune repeatedly
You can play the current tune repeatedly
(Repeat Play).
1 Press MODE to enter the
functions mode while playing a
tune you want to hear over again
on a cassette. This unit enters the
functions mode.
2 Press RPT (repeat), while still in
the functions mode, so that the
RPT indicator lights up on the
display.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level noise or humming between
tunes.
– Tapes with tunes recorded at low recording levels.
Prohibiting cassette ejection
You can prohibit cassette ejection and can “lock”
a cassette in the cassette compartment.
While holding TAPE
23, press 0 (eject) for more
than 2 seconds. “NO EJECT” flashes on the
display for about 5 seconds, and the cassette is
“locked.”
To cancel the prohibition and “unlock” the
cassette, While holding TAPE
23, press 0
(eject) for more than 2 seconds again. “EJECT
OK” flashes for about 5 seconds, and this time
the cassette is “unlocked.”
Note:
If you press
0 while cassette ejection is prohibited,
the cassette will not be ejected.
Lights up when Repeat Play is turned on.
MODE
11 RPT
EN09-11.KS-FX621[U] f 12/13/02, 8:41 AM 11