John Deere ET-3507-J - Manual (Page 12)

12 1/2-Inch Hammer Drill Operator's Manual
Operation
PRE-OPERATION (CONTINUED):
11. Confirm the direction of bit rotation:
The bit rotates clockwise (viewed from the rear side) by pushing the R-side of the
reversing switch lever.
The L-side of the lever is pushed to turn the bit counterclockwise. (Fig. 6)
CAUTION: NEVER CHANGE THE DIRECTION OF BIT ROTATION WHILE
OPERATING. TURN THE POWER SWITCH OFF BEFORE
CHANGING THE DIRECTION OF BIT ROTATION: OTHERWISE,
BURNING OF THE MOTOR WILL RESULT.
ALWAYS USE THE HAMMER DRILL WITH CLOCKWISE
ROTATION, WHEN USING IT AS A HAMMER DRILL. (FIG. 7)
(Fig. 6)
(Fig. 7)