John Deere ET-3507-J - Manual (Page 5)

1/2-Inch Hammer Drill Operator's Manual 5
KEEP YOUR WORK AREA CLEAN AND WELL LIT.
Cluttered benches and dark areas invite accidents.
DO NOT OPERATE POWER TOOLS IN EXPLOSIVE
ATMOSPHERES, SUCH AS IN THE PRESENCE OF
FLAMMABLE LIQUIDS, GASES, OR DUST. Power
tools create sparks which may ignite the dust of fumes.
KEEP BYSTANDERS CHILDREN, AND VISITORS
AWAY WHILE OPERATING A POWER TOOL.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
DOUBLE INSULATED TOOLS ARE EQUIPPED WITH
A POLARIZED PLUG (ONE BLADE IS WIDER THAN
THE OTHER.) THIS PLUG WILL FIT IN A POLAR-
IZED OUTLET ONLY ONE WAY. IF THE PLUG DOES
NOT FIT FULLY IN THE OUTLET, REVERSE THE
PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN TO INSTALL A POLAR-
IZED OUTLET. DO NOT CHANGE THE PLUG IN ANY
WAY. Double Insulation eliminates the need for the
three wire grounded power cord and grounded power
supply system.
AVOID BODY CONTACT WITH GROUNDED
SURFACES SUCH AS PIPES, RADIATORS, RANGES
AND REFRIGERATORS. There is an increased risk of
electric shock if your body is grounded.
DON'T EXPOSE POWER TOOLS TO RAIN OR WET
CONDITIONS. Water entering a power tool will
increase the risk of electric shock.
DO NOT ABUSE THE CORD. NEVER USE THE
CORD TO CARRY THE TOOLS OR PULL THE PLUG
FROM AN OUTLET. KEEP CORD AWAY FROM
HEAT, OIL, SHARP EDGES OR MOVING PARTS.
REPLACE DAMAGED CORDS IMMEDIATELY.
Damaged cords increase the risk of electric shock.
WHEN OPERATING A POWER TOOL OUTSIDE,
USE AN OUTDOOR EXTENSION CORD MARKED
“W-A” OR “W”. These cords are rated for outdoor use
and reduce the risk of electric shock.
WARNING