John Deere ET-3507-J - Manual (Page 7)

1/2-Inch Hammer Drill Operator's Manual 7
CAUTION
USE RIGHT TOOL
Don’t force small tool or attachment to do the job of a heavy-duty tool. Don’t use tool for
purpose not intended —for example— don’t use circular saw for cutting tree limbs or logs.
NEVER USE A POWER TOOL FOR APPLICATIONS OTHER THAN THOSE
SPECIFIED
Never use a power tool for applications other than those specified in the Instruction
Manual.
HANDLE TOOL CORRECTLY
Operate the tool according to the instructions provided herein. Do not drop or throw the
tool. Never allow the tool to be operated by children, individuals unfamiliar with its
operation or unauthorized personnel.
KEEP ALL SCREWS, BOLTS AND COVERS TIGHTLY IN PLACE
Keep all screws, bolts, and plates tightly mounted. Check their condition periodically.
DO NOT USE POWER TOOLS IF THE PLASTIC HOUSING OR HANDLE IS CRACKED
Cracks in the tool’s housing or handle can lead to electric shock. Such tools should not
be used until repaired.
BLADES AND ACCESSORIES MUST BE SECURELY MOUNTED TO THE TOOL
Prevent potential injuries to yourself or others. Blades, cutting implements and accesso-
ries which have been mounted to the tool should be secure and tight.
KEEP MOTOR AIR VENT CLEAN
The tool’s motor air vent must be kept clean so that air can freely flow at all times. Check
for dust buildup frequently.
SPECIFIC SAFETY RULES AND SYMBOLS
1.
HOLD TOOLS BY INSULATED GRIPPING SURFACES WHEN PERFORMING
AN OPERATION WHERE THE CUTTING TOOL MAY CONTACT HIDDEN
WIRING OR ITS OWN CORD. Contact with a “live” wire will make exposed metal
parts of the tool “live” and shock the operator.
2. Wear ear plugs when using the tool for extended periods. Prolonged exposure to
high intensity noise can cause hearing loss.
3. NEVER touch the tool bit with bare hands after operation.
4. NEVER wear gloves made of material liable to roll up such as cotton, wool, cloth
or string, etc.
5. ALWAYS attach the side handle and securely grip the Hammer Drill.
6. ALWAYS be careful with buried objects such as underground wiring. Touching
these active wiring or electric cables with this tool, you may receive an electric
shock.
Confirm if there are any buried objects such as electric cable within the wall, floor
or ceiling where you are going to operate here after.
7. Definitions for symbols used on this tool:
Volts = V
Hertz = Hz
Amperes = A
No load speed = n
o
Watt = W
Class II Construction =
Revolutions per minute = ---/min
WARNING