Jensen JiMS-182 - Manual (Page 8)

8
For nano 3
rd
generation For nano 4
th
generation For iTouch 2
nd
generation
It is always recommended you use the adaptor that comes with your iPod first. This will
help maximize a custom fit for your iPod when docked.
To place the iPod adapter
1. Select an adaptor and gently place it into the dock. Insert
the hooks of the adaptor into the socket of the docking bay.
2. Carefully push forwards and press down the adaptor.
To remove/replace the iPod adapter
1. Gently remove your iPod upwards.
2. Push the iPod adapter backwards and gently pull upwards.
DOCKING YOUR iPod
1. Press the POWER/STANDBY Button to turn on the unit.
2. Press the FUNC. Button to select iPod mode.
3. Select a suitable adaptor (included) or use the one that comes with your iPod
and insert it into the docking bay. Your iPod can now be inserted onto the
docking connector by aligning the connector on the bottom of the iPod onto the
connector in the docking bay.
Note : Please be careful when seating your iPod onto the dock to avoid
damaging the 30-pin connector in the iPod or the docking system.
4. The iPod will start playing and charging automatically.
Note: The iPod will only charge when the JiMS-182 is using the AC adaptor.
5. Adjust the sound level by pressing the / Buttons on the JiMS-182.
Note : The volume level cannot be adjusted using the volume control on your
iPod after being docked.
6. Press the or Buttons to skip to the previous or next song.
7. Press and hold the or Buttons to fast-backward or fast-forward during
playback.
8. To remove the iPod from JiMS-182, press and hold the Button for few
seconds to switch off the iPod and then gently remove it from the docking
connector.
9. To turn JiMS-182 off, press the POWER/STANDBY Button again.
ALARM OPERATION
Your JiMS-182 provides two different wakeup times, ALARM1 and ALARM2. You
can choose to use them independently or simultaneously: ALARM 1, ALARM 2 or
both ALARM 1 and ALARM 2.
Alarm Time Setting
Note: Alarm time (s) can only be set in Power Off mode.