John Deere PR-G7500M - Manual (Page 22)

22 Operator’s Manual
SERVICE
MAINTENANCE
AIR CLEANER:
WARNING: RISK OF FIRE OR EXPLOSION. DO
NOT USE GASOLINE OR LOW FLASH-POINT
SOLVENTS TO CLEAN THE ELEMENT. CLEAN
THE ELEMENT IN A WELL VENTILATED AREA.
ENSURE THAT NO SPARKS OR FLAMES ARE
NEAR THE WORKING AREA, THIS INCLUDES
ANY APPLIANCE WITH A PILOT LIGHT.
CAUTION: NEVER RUN THE ENGINE WITHOUT THE
AIR FILTER, SERIOUS DANGER CAN RESULT.
Check the air cleaner daily or before starting the engine.
Check for and correct heavy buildup of dirt and debris
along with loose or damaged components. (See Fig. 8)
1. Unsnap the air cleaner cover and remove the elements.
2. Clean the elements:
FOAM PRE-CLEANER ELEMENT: Wash the foam pre-
cleaner element in warm water with detergent. Rinse the
foam pre-cleaner element thoroughly until all traces of de-
tergent are eliminated. Squeeze out excess water, but do
not wring. Allow the foam pre-cleaner element to air dry.
Saturate the foam pre-cleaner element with new engine oil.
Squeeze out all excess oil. DO NOT put engine oil on the
foam damper.
NOTE: Clean the foam pre-cleaner element every 25 hours of opera-
tion (more often under extremely dusty or dirty condition)
PAPER AIR CLEANER ELEMENT: Do not wash the paper
element or use pressurized air, as this will damage the ele-
ment. Clean by gently tapping the element to remove dust.
Replace the element if damaged, bent or extremely dirty.
Handle new element carefully; do not use if the sealing
surfaces are bent or damaged.
NOTE: Replace the paper element every 100 hours (more often
under extremely dusty conditions.)
3. Reinstall the foam pre-cleaner element and the paper air
cleaner element. Close air cleaner cover and clasp shut.
(Fig. 8)