JVC 0803-CR-JMT - Manual (Page 21)

21
HV-34LH21/34LH51/34LH71/29WH21/29WH51/29WH71/29VH21 / GGT0020-001A-H / English
Using the TV’s menu
COLOUR
You can adjust the picture colour.
2
: lighter
3 : deeper
TINT
You can adjust the picture tint.
2
: reddish
3 : greenish
• You can change the TINT setting
(picture tint) only when the colour
system is NTSC 3.58 or NTSC 4.43.
• You cannot select the TINT function
when receiving the Progressive video
signal (525P signal).
To return to the default settings in each
PICTURE MODE:
Press the blue button. This will return the
picture settings in the currently chosen
PICTURE MODE to the default settings,
and stores them in the PICTURE MODE
again.
„ WHITE BALANCE
You can select one of three WHITE
BALANCE modes (three tones of white) to
adjust the white balance of the picture.
Since white is the colour which is used as a
reference for all the other colours, changing
the WHITE BALANCE mode affects the
appearance of all the other colours on the
screen.
COOL:
A bluish white. Using this mode when
watching bright pictures allows you to enjoy
a more vivid and bright picture.
MID:
The normal white colour.
WARM:
A radish white. Using this mode when
watching films allows you to enjoy colours
that are characteristic of films.
• You cannot select the WHITE
BALANCE function in the 16:9 mode
of the ZOOM function.
PICTURE FEATURES menu
„ DIGITAL VNR
The DIGITAL VNR function cuts down the
amount of noise in the original picture.
AUTO:
The TV will be automatically adjust the level
of the DIGITAL VNR effect to match the
amount of noise in the picture, giving you
the best possible picture.
• If you set the DIGITAL VNR effect too
high it can make the picture less sharp.
It is recommended to use the AUTO
setting if you can.
MAX:
The level of the DIGITAL VNR effect is set
to the maximum. If you set the DIGITAL VNR
function to AUTO but still notice some noise,
change the setting from AUTO to MAX.
• The MAX setting is not suitable for
high-quality pictures which contain a
lot of noise.
OFF:
The level of the DIGITAL VNR effect is set
to OFF.
MIN:
The level of the DIGITAL VNR effect is set to
the minimum. If you set the DIGITAL VNR
function to AUTO but feel that the sharpness
of the original picture has not been reproduced
fully, change the setting from AUTO to MIN.
• The MIN setting is not suitable for low-
quality pictures which contain a lot of noise.
HV-34LH&29WH_Eng.book.fm Page 21 Monday, September 1, 2003 7:59 PM