JVC AV-27F803 - Manual (Page 11)

INPUT 4
S VIDEO VIDEO
INPUT 1
R L MONO
AUDIO
OVER
R L MONO
R L
75Ω
(VHF / UHF)
AUDIO COMPONENT
VIDEO
COMPONENT
VIDEO
Y
P B
P R AV COMPULINK
AUDIO OUT
INPUT 2
WALL
CABLE or ANTENNA
OUT
11
Cable/RF connector
AV Cables/Plugs
Step Two - Making Basic Connections
Next you will need to connect your television to an antenna or cable system. The most basic
antenna/cable connection is shown below. For more detailed connections, such as ones where
a cable box is required, see pages 13 to 15.
You may also wish to connect a VCR at this point. A basic VCR connection is shown below. For
detailed instructions on connecting a other components or a home theater system, see pages
16 to 18.
Note: A VCR is not required to operate your television.
1) Connect the yellow video cable out from the VCR’s Video Output, in to the TV’s Video Input
jack, OR connect an S-Video cable from the VCR’s S-Video output, to the TV’s S-Video
input.
2) Connect the white audio cable out from the VCR’s Left Audio Output, in to the TV’s Left
Audio Input Jack.
3) Connect the red audio cable out from the VCR’s Right Audio Output, in to the TV’s Right
Audio Input jack.
Finally, once you have finished your connections, plug the power cord into the nearest power
outlet and turn on the television.
1) Connect an RF cable out from the wall outlet in to the RF Input on the back of the TV.
Proceed to Step Three
Quick Setup 2
Illustration of AV-27F803
INPUT 4
S VIDEO VIDEO
INPUT 1
R L MONO
AUDIO
OVER
R L MONO
R L
75Ω
(VHF / UHF)
AUDIO COMPONENT
VIDEO
COMPONENT
VIDEO
Y
P B
P R AV COMPULINK
AUDIO OUT
INPUT 2
OR
OR
IN
OUT
VCR
V L R
Illustration of AV-27F803
AV-27,32,36F703/713/803 English 6/14/02 5:07 PM Page 11