JVC AV-27F803 - Manual (Page 18)

Connections
18
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link input on your
VCR, DVD, or other Compu Link device. Plug the other end of the AV Compu Link cable into
the AV Compu Link input at the rear of the television.
Connecting to JVC AV Compu Link
JVC’s AV Compu Link feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape* into your JVC-brand VCR or DVD into your JVC DVD player and
the device will automatically turn on and begin playback. At the same time, using the
AV- CompuLink, the VCR or DVD player sends a signal to the television telling it to turn on
and switch to the proper video input
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you
wish to connect.If it is not, contact an authorized JVC Service Center for
part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
NOTES:
• In order for the VCR playback to begin automatically, the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR’s P
LAY button.
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “A Code/B Code Remote Control Switching” (see your VCR’s
instruction book), using VCR A Code will switch the TV to input 1.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the HiFi’s connection instructions for detailed connection information.
• AV COMPU LINK III is compatible with select AV CompuLink receivers.
INPUT 4
S VIDEO VIDEO
INPUT 1
R L MONO
AUDIO
OVER
R L MONO
R L
75Ω
(VHF / UHF)
AUDIO COMPONENT
VIDEO
COMPONENT
VIDEO
Y
P B
P R AV COMPULINK
AUDIO OUT
INPUT 2
AV
Compu
Link III
Swap
AV Compu Link III compatible
VCR or DVD Player
Illustration of AV-27F803
AV-27,32,36F703/713/803 English 6/14/02 5:07 PM Page 18