JMR electronic 1U SCSI JBOD - Manual (Page 11)

2. Place the device in the canister with the four screw holes aligned with the
holes in the device. Mount the drive by using the screws included with the
unit. (use all 4 screws to mount the drive).
3. Replace the canister into the unit.
4. Repeat steps 1 through 3 until all devices are installed.
5. Configure ID, and other options as required
6. Establish host connection
S Stto orrB Bllaad de e TM SCSI JBOD Installation Guide Rev A
3-2
StorBlade TM