JMR electronic 1U SCSI JBOD - Manual (Page 20)

2. Affix the extension bracket to the rear of the unit using two #10-32
screws. There are 3 holes in the extension bracket for mounting.
Depending on the hole pattern that is being used in the cabinet, two holes
should always be available for securing the extension bracket.
3. The fronts of the rails have three holes. Two of the holes (top and bottom)
are used to secure the rail to the cabinet. The middle hole is used to
secure the enclosure to the rail and cabinet. Secure the front of each rail
to the cabinet vertical rails using two #10-32 screws for each rail.
4. Slide the unit into the cabinet and secure it to the cabinet by tightening
the two embedded thumb screws.
S Stto orrB Bllaad de e TM SCSI JBOD Installation Guide Rev A
6-3
StorBlade TM