Jensen PORTABLE STEREO SPEAKER SYSTEM SMPS-125 - Manual (Page 3)

3
POWER SOURCES
The SMPS-125 can be operated by either battery or AC power (Batteries and AC adaptor
are not included).
AC adaptor Input: 120V~ 60Hz
Output: 6 V 400 mA
Batteries 4 x 1.5V ‘ ‘AAA’ (UM-4)
If batteries are installed and the AC adaptor is plugged in, the SMPS-125 will
automatically switch to AC power to conserve battery power.
POWER INSTALLATION
1. For AC power (AC Adaptor not included), insert the AC adaptor plug into the DC
Jack on the back of the SMPS-125.
2. For DC power, remove the battery compartment cover on the bottom of the cabinet
and insert 4 x ‘AAA’ (UM-4) batteries (not included) into the battery compartment.
Make sure to observe the correct polarity markings when installing the batteries.
Replace the battery compartment cover when finished.
IMPORTANT: Make sure that the batteries are installed correctly. Wrong polarity may
damage the unit and void the Warranty.
BATTERY CARE
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard or rechargeable batteries.
3. Only batteries of the same or equivalent type as recommend are to be used.
4. If the unit is not to be used for an extended period of time, remove the battery.
5. Do not dispose of batteries in fire, batteries may explode or leak.
6. Replace the batteries when the unit stops operating properly.
7. Remove exhausted batteries from the unit, dispose promptly and properly.
PRODUCT OVERVIEW
Top View
POWER INDICATOR
AUXILLARY INPUT 3.5 mm PLUG