Installation procedure, English – JVC TS-C50P6G User Manual

Page 39

Advertising
background image

10

English

The wall-hanging bracket weighs approximately 13.23 lbs., and the Wide Plasma Display unit weights
approximately 99.2 lbs.
While referring to the waIl-hanging bracket installation dimensions in the diagram below, check the strength of
the wall in six installation locations, and add reinforcing if any of these locations are not strong enough.

Installation procedure

• The wall-hanging bracket has installation holes provided in 24 locations.

lf the wall material will not allow sufficient strength to be obtained from using six installation holes, use some of the spare holes.
However, depending on the construction material used at the place of installation, cracks may develop if the screws are
inserted too close to each other.

N o t e

Note

N o t e

Note

Installation procedure

First screw a bolt into the centre-top
hole.
Use a level gauge to correct the
alignment of the wall-hanging

bracket, and then screw bolts into

the remaining five holes.
Provisionally tighten the fixing screws.
If the screws are inserted more than

13

/

64

inches, it will not be possible to

install the Wide Plasma Display in the

correct position.

1. Check the strength of the installation location.

2. Install the wall-hanging bracket to the wall.

Fixing screw

Fixing screw

lnstall the walI-hanging bracket so that the arrow shown on the bracket is pointing upwards.

If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracket
itself to determine the correct installation hole positions, or use the dimension diagram to calculate the hole
positions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow the
bolts to protrude from the wall by

13

/

32

inches to

19

/

32

inches.

36

5

/

8

19

19

/

64

17

23

/

32

1

31

/

32

1

1

/

4

51

/

64

51

/

64

17

23

/

32

17

23

/

32

3

15

/

16

19

/

32

19

/

32

Wall installation holes (6 locations)

Used for routing wires behind a wall

1

31

/

32

Units : inches

• Use commercially-available M6 bolts which suit the wall materials for installation to the wall.

Advertising
This manual is related to the following products: