JVC TS-C50P6G - Manual (Page 40)

11
English
• Place the display face down on top of a cloth which is clean and free from other foreign particles, and then carry out the
procedure above.
N o t e
Note
• Do not Iift the display too high, otherwise it may become unhooked.
N o t e
Note
Installation procedure
Push the upper insulating spacers
on the display into the notches at
the top of the wall-hanging bracket
until they are hooked in, and then
lower the display into place.
While lifting the display slightly,
insert the lower insulating spacers
on the display into the lower
horizontal hanging holes in the wall-
hanging bracket, and then lower the
display.
3. Prepare the Wide Plasma Display.
4. Install the display to the wall-hanging bracket.
Remove the four bolts.
Pan head bolt with hex socket
Toothed pan washer
Insulating spacer
1. Remove the four bolts from the display.
2. Use the accessory tool (Allen key) to
install the four accessory pan head
bolts with hex socket, toothed pan
washers and insulating spacers into the
holes where the four bolts used to be
as shown in the illustration.
• Attach the insulating spacers to the display.
Insulating spacer
Notches (for hanging horizontally)