Jensen JBX100SR - Manual (Page 6)

128-7041
6 of 12
1. Turn the Boom Box upside down to access
the battery compartment.
2. Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3. Insert eight (8) D-Cell batteries observing
battery polarity as shown; then close the cover.
3. Installing the Shuttle in the JBX100SR
Place the Shuttle in the cradle so that the Shuttle
guides are lined up with the JBX100SR cradle. Then
push the Shuttle forward to engage the connectors.
The Shuttle will snap into place. Apply power to the
JBX100SR by rotating the VOL control clockwise from
the off position; the LED indicator lights green. If the
Shuttle does not turn on at the same time, press the
red Power On/Off button in the upper left corner of
the Shuttle front panel.
-6-
BATTERY
COMPARTMENT
COVER
BOTTOM OF
BOOM BOX
BATTERY COMPARTMENT
COVER LATCHES
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE
POSITIVE NEGATIVE
POSITIVE
2. Cabling Interconnections
You can begin to enjoy Sirius® Satellite Radio
as soon as the Shuttle and Boom Box Kit
installation are complete. Set up your Jensen
JBX100SR by following the interconnect diagram.
4. Removing the Shuttle From the JBX100SR
Press and hold the eject button on
top of the Boom Box; the
Shuttle will partially eject
forward. Using your thumb
and forefinger, grasp the
Shuttle on the sides and pull
forward to disengage.