JVC GD V500PZU - Manual (Page 6)

11
Basic Controls
R - STANDBY
G POWER ON INPUT – VOL +
Main Power On/Off Switch Volume Adjustment
Push the Volume Up “+” or
Down “–” button to
increase or decrease the
sound volume level.
Input button
(VIDEO (S-VIDEO)/COMPONENT,
RGB/PC Mode Selection)
Push the “INPUT” button to select
VIDEO(S-VIDEO)/COMPONENT or
RGB/PC input signal modes sequentially. Power Indicator
The Power Indicator will light.
• Power-OFF .... Indicator not illuminated (The unit
will still consume some power as long as the
power cord is still inserted into the wall outlet.)
• Stand-by .... Red
• Power-ON ..... Green
OFF TIMER button
The Plasma Display Monitor may be preset to switch to stand-by after a fixed period.
The setting changes to 30 minutes, 60 minutes, 90 minutes and 0 minutes (off timer
cancelled) each time the button is pressed.
When three minutes remain, “Off timer 3” will flash.
The off timer is cancelled if a power interruption occurs.
30 60
0
90
PC button
Push the “PC” mode selection
button to select the PC mode.
This button is used to switch
directly to PC mode.
INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
ASPECT
PICTURE
POS. /SIZE
OFF TIMER PC
Input button
(VIDEO(S-VIDEO)/COMPONENT,
RGB/PC Mode Selection)
Press to select VIDEO(S-VIDEO)/
COMPONENT or RGB/PC input signal
modes sequentially. (see page 19)
Sound mute On/Off (see page 26)
Volume Adjustment
Press the Volume Up “+” or Down
“–” button to increase or decrease
the sound volume level.
ACTION button
Press to make selections
ASPECT button
Press to adjust the aspect.
(see page 22)
SOUND button (see page 26)
SET UP button (see page 30)
POSITION buttons
R button (see page 21, 24, 26, 30)
Stand-by (ON/OFF) button
The Plasma Display Monitor must first be plugged
into the wall outlet and turn on at the power switch
(see page 18).
Push this button to turn the Plasma Display Monitor ON,
from STANDBY mode. Push it again to turn the Plasma
Display Monitor OFF to STANDBY mode.
SURROUND button
(see page 27)
N button
(see page 25, 26, 28, 29)
PICTURE button
(see page 28)
PICTURE POS./SIZE button
(see page 24)
Status button
Push the “Status” button to display
the current system status.
1 VIDEO(S-VIDEO)/COMPONENT,
RGB/PC mode
2 Aspect mode (see page 22)
3 Off timer
The off timer indicator is displayed
only when the off timer has been set.
OFF TIMER 90
1
2
3
V I D E O
N O R M A L
12
Connections
To tighten:
Pull
Pull
To loosen:
Push
the knob
S-VIDEO VIDEO VD HD P R /C R /R P B /C B /B Y/G
L
R
L
R
AUDIO AUDIO
AUDIO
SERIAL TUNER IN PC IN COMPONENT/RGB IN AV IN
AV IN Terminals
(see page 13, 14)
COMPONENT/RGB IN and Audio IN Terminals
(see page 15)
From SERIAL Terminal on Computer
(see page 17)
From EXIT monitor Terminal
on Computer (see page 16)
SPEAKER
Terminals (R) SPEAKER
Terminals (L)
– Cable fixing bands
Secure any excess cables with bands, as required.
From TUNER signal out Terminal
The TUNER Terminal is reserved
for future use.
9
GD-
V
500PZ
U