JVC GD V500PZU - Manual (Page 8)

15
Connections
How to connect the COMPONENT/RGB Input Terminals
RGB signal (R, G, B, HD, VD) connection
Notes:
(1) Change the “COMPONENT/RGB-IN” setting in the “SET UP” menu to “Y/PB/PR”. (see page 30, 32)
(2) Additional equipment and cables shown are not supplied with this set.
Component signals (Y, P B , P R ) connection
Notes:
(1) Change the “COMPONENT/RGB-IN” setting in the “SET UP” menu to “RGB”. (see page 30, 32)
(2) Additional equipment and cables shown are not supplied with this set.
VD HD P R /C R /R P B /C B /B Y/G
L
R
COMPONENT/RGB IN
RGB input to
R, G, B, HD, VD sockets
Audio input to
L/R sockets
AUDIO
VD
HD
2 × RCA audio cables
5 × BNC
RGB cables
Example of input signal source
HDTV-compatible VCR
or
RGB camera
AUDIO
DVD Player
Audio OUT R L
DVD (Y,PB, PR) OUT
Y PB PR
Audio input to L/R sockets
RCA-BNC
adapter plug
AUDIO
2 × RCA audio cables
3 × RCA
video cables
VD HD P R /C R /R P B /C B /B Y/G
L
R COMPONENT/RGB IN
Y, P B , P R
AUDIO
16
Connections
How to connect the PC Input Terminals
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed if signals exceeding 1200 lines will not
be displayed properly.)
(2) The display resolution is a maximum of 1024 × 768 dots when the aspect mode is set to “NORMAL”, and 1366 × 768
dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
(3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you
will need to make setting changes to the computer at the time of connection.
(4) Some PC models cannot be connected to the set.
(5) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(6) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(7) The computer shown in the illustration is for example purposes only.
(8) Additional equipment and cables shown are not supplied with this set.
(9) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
Pin No.
1
2
3
4
5
Pin No.
6
7
8
9
10
Pin No.
11
12
13
14
15
Signal Name
R
G
B
GND (Ground)
GND (Ground)
Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
Signal Name
GND (Ground)
SDA
HD/SYNC
VD
SCL
AUDIO
PC IN
COMPUTER
Conversion adapter (if necessary)
Audio
RGB
D-sub 15p
1/8" (3mm) stereo plug
PC cable
Connect a cable which matches
the audio output terminal on the computer.
POWER / R - STANDBY G POWER ON INPUT – VOL +
Pin layout for PC input
terminal
1
6 7 8
3
9
4 5
10
15 14 13 12 11
2
11
GD-
V
500PZ
U