JVC GR-DVL522 - Manual (Page 51)

EN
51
Dubbing To A Video Unit Equipped With A
DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from this
camcorder onto another video unit equipped with a
DV connector. Since a digital signal is sent, there is
little if any image or sound deterioration.
[To use this camcorder as a player]
1
Make sure all units are turned off. Connect this
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the
illustration.
2
Set this camcorder’s VIDEO/MEMORY Switch to
“VIDEO”, then the Power Switch to “PLAY” while
pressing down the Lock Button located on the switch,
turn on the video unit’s power, and insert the
appropriate cassettes in this camcorder and the video
unit.
3
Engage the video unit’s Record-Pause mode.
4
Engage this camcorder’s Play mode to find a spot
just before the edit-in point. Once it is reached, press
4 / 6 on this camcorder.
5
Press 4 / 6 on this camcorder and engage the
video unit’s Record mode.
6
Engage the video unit’s Record-Pause mode and
press 4 / 6 on this camcorder.
7
Repeat steps 4 through 6 for additional editing,
then stop the video unit and this camcorder when
finished.
NOTES:
●
It is recommended to use the AC Adapter as the
power supply instead of the battery pack (
੬
pg. 9).
●
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
●
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 5. If this
occurs, turn off the power and make connections again.
● If “Playback Zoom” (
੬
pg. 57), “Playback Special
Effects” (
੬
pg. 56) or “Snapshot” is attempted during
playback, only the original playback image recorded on
the tape is output from the DV IN/OUT connector.
● When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
MANUAL
AUTO
PLAY
OFF
DV cable
(optional)
Video unit equipped with
DV input connector
To DV IN
To DV
IN/OUT
Power Switch
Core filter
Core filter
VIDEO/MEMORY Switch
Lock
Button