JVC GR-DVL522 - Manual (Page 52)

52
EN DUBBING
(cont.)
MANUAL
AUTO
PLAY
OFF
DV cable
(optional)
Video unit equipped with
DV output connector
To DV OUT
To DV
IN/OUT
Power Switch
Core filter
Core filter
VIDEO/MEMORY Switch
Lock
Button
Dubbing From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
[To use this camcorder as a recorder]
1
Make sure all units are turned off. Connect this
camcorder to a video unit equipped with a DV output
connector using a DV cable as shown in the
illustration.
2
Set this camcorder’s VIDEO/MEMORY Switch to
“VIDEO”, then the Power Switch to “PLAY” while
pressing down the Lock Button located on the switch.
Turn on the video unit’s power and insert the
appropriate cassettes in this camcorder and the video
unit.
3
Set “REC MODE” to “SP” or “LP” in the Menu
Screen depending on your preference (
੬
pg. 48).
4
Press the Recording Start/Stop Button on this
camcorder to engage the Record-Pause mode.
“
DV. IN ” appears on the screen.
5
Engage the video unit’s Play mode, then engage
the Still Playback mode when you have found a spot
just before the edit-in point.
6
Press the Recording Start/Stop Button on this
camcorder to engage the Record mode. rotates
on the screen. Engage the video unit’s Play mode.
7
To stop dubbing, press the Recording Star/Stop
Button on this camcorder so that stops rotating,
then engage the video unit’s Stop mode.
8
Repeat steps 5 through 7 for additional editing.
NOTES:
●
It is recommended to use the AC Adapter as the power supply instead of the battery pack (
੬
pg. 9).
●
If the remote control is used when both the player and recorder are JVC video units, both units will perform the same
operation. To prevent this from happening, press the buttons on both units.
●
If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
●
Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn
off the power and make connections again.
●
When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
●
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND
MODE” setting (
੬
pg. 45).
●
During Digital Dubbing, no signals are output from the video or audio connectors.