JVC GR-DVL517 - Manual (Page 10)

10
EN
2
PAUSE
1
3
Grip Adjustment
1 Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust your thumb and fingers through the grip,
to easily operate the Recording Start/Stop button
and Power Switch and Power Zoom Lever. Be
sure to fasten the Velcro strip to your preference.
Viewfinder Adjustment
1
Set the Power Switch to “ ” or “ ” while
pressing down the Lock Button located on the
switch.
2 Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly
focused.
Diopter
Adjustment Control
Power Switch
GETTING STARTED (cont.)
Shoulder Strap Attachment
1
Make sure the battery pack is removed.
Following the illustration, thread the strap
through the eyelet
1 , then fold it back and
thread it through the buckle 2 . Repeat the
procedure to attach the other end of the strap to
the other eyelet
3 located under the Grip Strap .
Confirm the strap is not twisted.
CAUTION:
When attaching the camera to a tripod,
extend its legs to stabilize the camcorder. It
is not advised to use small sized tripods.
This may cause damage to the unit by
falling over.
1
To attach the camera to a tripod, align the
direction stud and screw to the mounting socket
and stud hole on the camera. Then tighten the
screw clockwise. Some tripods are not
equipped with studs.
Power Zoom Lever
Recording Start/
Stop button
Tripod Mounting