Installing the battery pack – JVC GR-DLS1 User Manual

Page 9

Advertising
background image

EN

9

Charging Environment

Perform charging where the temperature is between 10° and 30°C. (20° to 25°C is the ideal temperature range for
charging.) If the environment is too cold, charging may be incomplete.

Continuous Shooting

Continuous shooting is possible (See table below for recording time) under the following conditions:
•The temperature is approximately 20°C
However, . . .
•If the temperature is below 10°C, or
•If zoom or Record-Standby are engaged or LCD monitor is used repeatedly, continuous shooting capability

is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to
cover 3 times the planned shooting time.

1

OPEN BATTERY COVER

Slide the open switch.

2

INSERT CHARGED BATTERY

Insert the

mark end of the battery first until

you hear a click. The hook rises. Inserting the
battery backwards will result in malfunction.

3

CLOSE BATTERY COVER

Battery

Battery cover

Hook

Open switch (BATTERY)

NOTES:

● To remove the battery, turn off the camcorder,

open the battery cover and push down the hook.

● Be careful not to drop the battery pack.

● The hook is tight to prevent the battery from

dropping.

● See the Additional Reference Manual for more

information on using the Battery Pack BN-V856U.

Approximate recording time

Battery Pack
BN-V814U

BN-V856U

LCD monitor off/Viewfinder on

1 hr. 40 mim.*

3 hrs.**

6 hrs.

LCD monitor on/Viewfinder off

1 hr. 20 mim.*

2 hr. 20 mim.**

5 hrs.

* Using one battery installed in the camcorder
** Using two batteries; one in the camcorder and one in the provided Power Pack attached to the camcorder

Installing The Battery Pack

The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has
been charged fully.

Advertising