JAI IIT Camera Systems VIS-CAM 400 - Manual (Page 18)

IIT Camera System Manual
18 Installation
3.2 Installing the Camera
The camera is mounted using the same VIS Mount as VIS-CAM Systems (300/350/400). Please refer to
section 3.2 in the VIS-CAM System Installation manual for camera mount template and mounting
instructions.
3.2.1 Opening the Camera Housing
The rear plate can be removed by loosening the two screws marked “1” below. Once they are loose
they can be turned by fingers. The screws are retained by springs.
When the rear plate is removed the drawer holding the electronics can be pulled out after removing
the two screws marked “3” in figure B.
The lid is held by a drawbar as shown in figure C (inside view) and figure D of the lid taken off. To
take off the lid the two screws marked “2” in figure A are loosened. Start by turning the screws 6-7
turns counterclockwise and then push them gently back in using the screwdriver. Repeat this until
the screws cannot be pushed in any more. The lid can then be taken off.