Single-tagged interfaces, Table 4: show ethernet delay command parameters – Juniper Networks JUNOS OS 10.4 User Manual

Page 151

Advertising
background image

NOTE:

The only difference in the two commands is the use of the

mep-statistics

and

delay-statistics

keyword.

The fields for these commands are described in

Table 4 on page 131

.

Table 4: Show Ethernet Delay Command Parameters

Description

Parameter Range

Parameter

Specifies an existing maintenance domain (MD) to use.

Existing MD name

maintenance-domain name

Specifies an existing maintenance association (MA) identifier
to use.

Existing MA identifier

maintenance-association ma-id

When a MEP has been specified, display statistics only for the
local MEP.

1–8191

local-mep identifier

When a MEP has been specified, display statistics only for the
discovered MEP.

1–8191

remote-mep identifier

The number of entries to display in the results table. By default,
all 100 entries are displayed if they exist.

1–100 (default:100)

count

count

NOTE:

For each MEP, you will see frame counters for sent and received

Ethernet frame delay measurement frames whenever MEP statistics are
displayed.

Related

Documentation

Ethernet OAM

•

•

Ethernet Frame Delay Measurements on page 125

•

Configuring MEP Interfaces to Support ETH-DM on page 128

•

Triggering an ETH-DM Session on page 129

•

Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 131

•

Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 136

•

Configuring ETH-DM with Untagged Interfaces on page 140

Example: Configuring One-Way Ethernet Frame Delay Measurements with
Single-Tagged Interfaces

This example uses two MX Series routers:

MX-1

and

MX-2

. The configuration creates a

CFM down MEP session on a VLAN-tagged logical interface connecting the two (

ge-5/2/9

on Router

MX-1

and

ge-0/2/5

on Router

MX-2

).

131

Copyright © 2013, Juniper Networks, Inc.

Chapter 11: ITU-T Y.1731 Ethernet Frame Delay Measurements

Advertising