JVC LPT0827-001B - Manual (Page 90)

Filename [DR-M1EK_10Editing.fm]
Masterpage:Left0
Page 90 August 15, 2003 7:53 pm
90
SYSTEM CONNECTIONS
Connecting To A Satellite Receiver
Connect the satellite receiver to the L-2 IN/DECODER connector, then connect the L-1 IN/OUT connector to the TV’s
connector.
NOTES:
● Set “L-2 SELECT” to “VIDEO” or “S-VIDEO”. ( ੬
pg. 85)
● You can use the Automatic Satellite Programme Recording function ( ੬
pg. 65) with this connection.
● To record a programme via the satellite receiver, select L-2 mode by pressing PR +/– so that “L-2” appears on the front display panel.
● For details, refer to the instruction manual of the satellite receiver.
IMPORTANT:
When you set “L-2 SELECT” to “SAT VIDEO” or “SAT S-VIDEO” (
੬
pg. 85, “L-2 Select Setting (L-2 SELECT)”), it is possible to view
a satellite broadcast with the TV set to its AV mode even if the unit is turned off. When the unit is in Stop mode or recording, press
on the remote control to turn off the VIDEO indicator on the unit.
● If you turn on the unit when the satellite receiver’s power is off, nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or press on the remote control to set the unit to the AV mode.
Outdoor unit
Satellite cable
Satellite receiver
Aerial
TV aerial cable
21-pin SCART connector
Back of TV
Aerial connector
Mains outlet
Back of unit
ANTENNA IN
ANTENNA OUT
DR-M1EK_01.book Page 90 Friday, August 15, 2003 7:53 PM