Manual channel set, Pg. 99), Access the main menu screen – JVC LPT0827-001B User Manual
Page 99: Access the confirmation screen, Select the channel position. important
Masterpage:Right-No-Heading
Filename [DR-M1EK_11Subsidiary.fm]
Page 99
August 15, 2003 7:53 pm
99
NOTES:
● Fine tuning is performed automatically during Auto Channel
Set. If you want to perform tuning manually, refer to “Fine-
Tuning Channels Already Stored” (
● If you perform Auto Channel Set when the aerial cable is not
connected properly, “SCAN COMPLETED –NO SIGNAL–”
appears on the TV screen in step
C. In such a case, make sure
of the aerial connection and press ENTER; Auto Channel Set
will start again.
Manual Channel Set
Store channels that were not stored during Auto Set Up
(
pg. 23) or Auto Channel Set
A
Access the Main Menu screen.
Press SET UP.
B
Access the Confirmation screen.
A Press w e to select “INITIAL SET UP”, then press
ENTER.
B Press w e to select “MANUAL CH SET”, then press
ENTER.
● The Confirmation screen appears.
C
Select the channel position.
IMPORTANT:
● In certain reception conditions, station names may not be
stored correctly, and Auto Guide Program Number Set may
not work properly. When the Guide Programme numbers
are not set properly, the programme that you do not
intended to record will be timer-recorded by the VIDEO
Plus+ system of the unit. When programming the timer
using the VIDEO Plus+ system, be sure to check the
desired channel is selected correctly. (
● Your unit memorises all receivable stations even if
reception of some of them is poor. You can delete those
stations with an unacceptable picture from the list.
(
Press rt w e to select a
blank position in which you
want to store a channel, then
press ENTER twice. The
Manual Channel Set screen
appears.
(Example) To store in position 6.
The programme currently received
on the selected channel position
appears behind the confirmation
screen.
DR-M1EK_01.book Page 99 Friday, August 15, 2003 7:53 PM