JVC GR-DVL105 - Manual (Page 12)

12
EN
2 5
90 min 89 min 3 min
2 min 1 min 0 min
min
180
°
90
°
BR I GHT – +
PL
AY
O
FF
RECORDING Basic Recording
Tally lamp
(lights while
recording is
in progress)
Lock Button
Tape remaining
time indicator
(Approximate)
(Now calculating)
(Blinking) (Blinking) (Blinking)
Display
MENU/
BRIGHT Wheel
Power Switch
PUSH OPEN Button
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
੬
pg. 6)
● Grip Adjustment (
੬
pg. 8)
● Viewfinder Adjustment (
੬
pg. 8)
● Load A Cassette (
੬
pg. 10)
● Recording Mode Setting (
੬
pg. 11)
1
Press in the tabs on the lens cap to remove it.
2
Set the Power Switch to “ ” or “ ” while pressing
down the Lock Button located on the switch.
Shooting while using the LCD monitor: Press PUSH
OPEN and open the LCD monitor fully. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. “PAUSE” is displayed.
3 Press the Recording Start/Stop Button. “ ” appears
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the bright level indicator
on the display moves and the appropriate brightness is
reached.
During
shooting
Power lamp
Recording
Start/Stop Button