JVC GR-DVL105 - Manual (Page 54)

54
EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
26. •In places subject to low
temperature, images
become dark due to the
characteristics of the LCD
monitor. When this
happens, the displayed
colours differ from those
that are actually recorded.
This is not a defect of the
camcorder.
•When the LCD monitor’s
fluorescent light reaches the
end of its service life,
images on the LCD monitor
become dark. Consult your
nearest JVC dealer.
27. •The light used to illuminate
the LCD monitor causes it to
become hot.
28. •This may occur when the
surface or the edge of the
LCD monitor is pressed.
29. •Certain Fade/Wipe effects,
certain modes of
Programme AE with special
effects, “DIS” and other
functions that cannot be
used together are selected at
the same time.
30. •The LCD monitor and the
viewfinder are made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not
recorded on the tape. This is
not due to any defect of the
unit. (Effective dots: more
than 99.99 %)
26. •Adjust the brightness and
angle of the LCD monitor
(
੬
pg. 12, 13).
27. •Close the LCD monitor to
turn it off or set the Power
Switch to “OFF”, and let the
unit cool down.
28.
————
29. •Re-read the sections
covering Fade/Wipe effects,
Programme AE with special
effects and “DIS”
(
੬
pg. 22, 24 – 26).
30.
————
26. Images on the LCD
monitor appear dark or
whitish.
27. The rear of the LCD
monitor is hot.
28. The indicators and the
image colour on the LCD
monitor are not clear.
29. The LCD monitor or
viewfinder indications
blink.
30. Coloured bright spots
appear all over the LCD
monitor or the viewfinder.
TROUBLESHOOTING (cont.)