JVC GY-HM700U - Manual (Page 117)

113
Stream Transmission to a Non-linear
Editing System
Playback images on the camera recorder can be stream
output during editing using a non-linear editing system.
ⅥLoading to a Non-linear Editing System
in Play Mode
1
Perform the following settings on the camera
recorder.
A Set the [HD/DV] IEEE1394 terminal mode switch to
ADVB.
B Set the [INT/EXT] IEEE1394 interface terminal switch to
AEXTB.
Memo :
● Stream transmission is only possible for DV format images.
2
Connect the IEEE1394 cable.
3
Turn on the power of both the camera recorder and
non-linear editing system.
4
Set the camera recorder to Media mode.
Press the [CAM/MEDIA] selection button to switch to Media
mode. (
A Page 7)
Note :
● Start recording only after ensuring that the devices are
properly connected.
5
Insert the media to be dubbed.
6
Press the play button (center of the cross-shaped
button) on the camera recorder.
Playback starts.
7
Start loading to the non-linear editing system.
For details, refer to the instruction manual of the non-linear
editing system.
8
Loading is complete.
After loading is complete, press the [CANCEL] button on the
camera recorder to stop playback.
Memo :
● Switch the [HD/DV] IEEE1394 terminal mode switch only
after turning OFF the power of the camera recorder.
● The operating procedures vary depending on the
characteristics and specifications of the connected devices,
and transfer of data may fail even when the devices are
properly connected.
● If noise appears on the screen or audio sound is interrupted,
reconnect the IEEE1394 cable or turn on the power of the
camera recorder again.
● Noise may occur in the audio when you turn ON/OFF the
power of the device connected to the [IEEE1394] terminal.
Before performing any of these operations, lower the volume
of the device connected to the camera recorder to the
minimum.
Camera recorder : Recorded SDHC card
IEEE1394
Cable
Signal Flow
[HD/DV] IEEE 1394
Terminal Mode
Switch
[IEEE1394] Terminal
PC
[INT/EXT] IEEE1394
Interface Terminal
Switch