JVC GY-HM700U - Manual (Page 91)

87
* Default values are indicated in bold characters.
Item Setting Values Function
Audio Monitor Stereo
Mix
For setting the audio sound of the [PHONES] terminal to stereo or mixed sound when the
[MONITOR SELECT] switch on the side of the camera recorder is set to
ABothB.
Mix : Outputs mixed sound (outputs mixed sound of CH-1 and CH-2 to both L and R).
Stereo : Outputs stereo sound (outputs audio sound of CH-1 to L, and CH-2 to R). When a
monitor speaker is used, only the audio sound of CH-1 is output.
Ⅵ [PHONES] terminal, speaker, and RCA outputs according to the combination of the camera
recorder’s [MONITOR SELECT] switch settings and [Audio Monitor] settings.
[MONITOR
SELECT] Setting
[Audio Monitor]
Setting
Output from [PHONES]
Terminal
Speaker
Output
RCA Output
L R CH1 CH2
[CH-1] ^ CH1 CH1
CH1 CH2
[BOTH] [Mix] CH1+CH2 CH1+CH2
[Stereo] CH1 CH2 CH1
[CH-2] ^ CH2 CH2
Others Menu
Item Setting Values Function
Alarm Level High
Middle
Low
Off For selecting whether to turn on the alarm tone as well as setting the volume.
Alarm tone is output from the monitor speaker or [PHONES] terminal.
High
: Outputs alarm tone at a high volume level.
Middle : Outputs alarm tone at a medium volume level.
Low
: Outputs alarm tone at a low volume level.
Off : Alarm tone is not output.
Mode LED On
Off For specifying the illumination settings of the operation mode indicator on the side control panel
of the camera recorder.
On
: Lights up as below according to the operation mode. ( A Page 7)
Off : Turns off the indicator.
Operation Mode Color
Camera Mode Blue/Purple
Media Mode (SD Card Mode) Green
Media Mode (IEEE1394 Mode) Orange
USB Mode Orange
Tally System Studio
Ext
Int
For setting the display conditions of the camera recorder’s tally lamps (front/back).
Studio : Displays according to the TALLY IN/PREVIEW IN signals from an external device,
such as a remote control.
Ext : Displays mainly the status of external devices.
Int : Displays mainly the status of the camera recorder.
Front Tally
On
Blink
Off
For specifying the illumination settings of the camera recorder’s front tally lamp during recording.
On
: Lights up only during recording.
Blink : Blinks after the [REC] trigger button is pressed until recording starts, and lights up
during recording.
Off : Turns off the tally lamp.
Back Tally
On
Blink
Off
For specifying the illumination settings of the camera recorder’s back tally lamp during
recording.
On
: Lights up only during recording.
Blink : Blinks after the [REC] trigger button is pressed until recording starts, and lights up
during recording.
Off : Turns off the tally lamp.