JVC GR-DVJ70 - Manual (Page 52)

52
EN
Random Assemble Editing
Using the RM-V708U or RM-V710U remote control, you can use P.AE/Effects and make an original edited
tape.
1 MAKE CONNECTIONS
Connect the Docking Station to your VCR and
make sure that the playback picture and sound
are available on the connected TV (
੬
pg. 43).
NOTES:
● When using a JVC VCR with a remote pause terminal,
connect the editing jack on the Docking Station to the
VCR’s remote pause terminal using an editing cable.
● If the VCR has an S-Video input terminal, connect it
using an S-Video cable.
● If the VCR has only one audio input terminal, connect it
using a conversion plug.
● Set the VIDEO OUT select switch of connector as
required: either to “CVBS” (with the direct VCR
connection) or to “YC” (with the RGB converter
connection).
To Operate The VCR With The Remote Control . . .
..... press and hold SHIFT, then press the
appropriate control button.
2 START SOURCE PLAYBACK
Press PLAY and then press R.A. EDIT ON/OFF
on the remote control. Make sure to point the
remote control at the Docking Station's sensor.
•The Random Assemble Editing Menu appears
on the TV screen.
•If you're not using a Fade/Wipe at the
PROGRAMME 1 Edit-In point, go to step 4.
3 EXECUTE FADE/WIPE IN
Press FADE/WIPE.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•You can’t use a Picture Wipe/Dissolve at the
beginning of Programme 1, or at the end of
the last scene.
EDITING (Cont.)
T W
NEW TAPE (VCR)
TO EDITING JACK
TO REMOTE PAUSE
JACK
EDITING CABLE
TO S-VIDEO
OUTPUT JACK
TO AUDIO
INPUT JACKS (L/R)
SOURCE TAPE (Camcorder)
S-VIDEO CABLE
TO VIDEO INPUT JACK
TO AUDIO OUTPUT JACKS (L/R)
TO VIDEO OUTPUT JACK
VCR (Recording deck)
TO S-VIDEO
INPUT JACK
Cable adapter (provided)
If your VCR has the 21-pin AV
input connector (SCART), use
the provided cable adapter.
AUDIO and VIDEO cable
VIDEO OUT
select switch
(Y/C or CVBS)
RM-V708U or
RM-V710U