JVC GR-DVJ70 - Manual (Page 9)

EN
9
Installing The Battery Pack
The battery pack does not charge while in the
camcorder. Before installation, make sure the
battery pack has been charged fully.
1 OPEN BATTERY COVER
Move the cover in the direction of the arrow.
2 INSERT BATTERY
Remove its protective cap and insert the + –
end of the battery first.
3 CLOSE BATTERY COVER
NOTE:
To remove a discharged battery pack, simply open
the cover and slide the battery pack out.
BATTERY COVER
BATTERY
NOTES:
● If you connect the camcorder’s DC cord to the
adapter during battery charging, power is
supplied to the camcorder and charging stops.
● When using the AC Power Adapter/Charger, be
sure to use the supplied power cord only.
● When charging the Battery Pack for the first time
or after a long storage period, the Charge
Indicator may not light. In this case, remove the
Battery Pack from the AC Power Adapter/Charger,
then try charging again.
● Since the AC Power Adapter/Charger processes
electricity internally, it becomes warm during use.
Be sure to use it only in well-ventilated areas.
● Be sure to securely connect the power cord to the
AC Power Adapter/Charger.
● Before connecting to an AC outlet, connect the
power cord to the AC Power Adapter/Charger. If
you plug into an AC outlet first and the power
cord’s terminal comes in contact with a metal
surface or object, there is the possibility of a short
circuit or fire.
** Charging Environment
Perform charging where the temperature is between
10° and 30°C. (20°–25°C is the ideal temperature
range for charging.) If the environment is too cold,
charging may be incomplete.
Recording Time
Recording time under the following conditions:
• The temperature is approximately 20°C
However, . . .
• If the temperature is below 10°C, or
• If Zoom or RECORD/STANDBY are engaged
repeatedly, continuous shooting capability is
reduced significantly. Before extended use, it is
recommended that you prepare enough battery
packs to cover 3 times the planned shooting time.
BATT. PACK RECORDING TIME
BN-V712U approx. 30 min.
BN-V714U approx. 50 min.