JVC AV 20420 - Manual (Page 10)

These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Before you can operate your remote control, you first need to install the batteries (included).
Raise the latch on the remote's back cover to remove. Insert two batteries carefully noting the
“+” and “–” markings, placing the “–” end in the unit first. Snap the cover back into place.
Getting Started
Step 1 – The Remote Control
10
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The
top and bottom buttons will scan forward and back
through the available channels. To move rapidly through
the channels using JVC’s
Hyperscan feature, press
and hold CH+ or CH–. The channels will zip by at a rate
of five channels per second. The right and left buttons
will turn the volume up or down. These buttons are
also marked with four arrows and are used with JVC’s
onscreen menu system. To use the onscreen menus,
press the M
ENU
button.
�������
�����
������� �����
�
�
�
����
�
�
�
�������
������
����
�������
����
�
�
�
�
�
��
��� ���
�
��
�������
�����������
����� ������
��� ���� �����
���� �� ���
�����
�����
�����
������
�������
Note: Illustration of remote
control RM-C205
Quick Setup Getting Started
AV-20420,421 English OK 2/11/03, 9:33 AM 10