JVC AV 20420 - Manual (Page 37)

Button Functions
37
The return+ button has two functions:
Return - Returns to the channel viewed just before the channel currently onscreen.
Return+ - Lets you program a specific channel to return to while scanning through the
channels using the CH+ and CH– buttons.
R
ETURN
+ and hold for three seconds
The channel currently active has been programmed as your return+ channel. Now scan
through the channels using the C
HANNEL
+/– buttons.
R
ETURN
+
You will return to your programmed channel.
• To cancel your return+ channel, press and hold the R
ETURN
+ button for three seconds. The
message “RETURN CHANNEL CANCELLED!” will appear.
• Return+ works only with the Channel+/– buttons. Pressing any number key will cancel
return+.
RETURN CHANNEL
PROGRAMMED !
Return +
Turns the TV on or off.
Press the P
OWER
button
Power
Use the number buttons on the remote control to move directly to a specific channel. For
example, to move to channel 7:
0 (Zero)
7 (Seven)
Number Buttons - 10Key Pad
Use the 100+ button to directly access channels above channel 99. For example, to move to
channel 124, press 100+, 2 (Two), 4 (Four).
100+ Button
Use these buttons to move up or down all the available channels your TV is able to recieve.
Channel +/–
Use these buttons to raise or lower the TV’s volume level.
Volume +/–
AV-20420,421 English OK 2/11/03, 9:34 AM 37