JVC RX-7520VBK - Manual (Page 41)

38
English To change the transmittable signals for
operating a VCR
1 Press and hold STANDBY/ON VCR.
2 Press VCR.
3 Enter manufacturer’s codes using buttons 1 – 9,
and 0.
4 Release STANDBY/ON VCR.
Now, you can perform the following operations on the VCR.
STANDBY/ON VCR : Turn on or off the VCR.
VCR CH +/– : Change the channels.
After pressing VCR (source selecting button), you can use the
following buttons on the VCR:
3 : Start playback.
FF : Fast-wind a tape.
REW : Rewind a tape.
7 : Stop playback or recording.
8 : Pause playback. To release it, press 3 3 3 3 3.
REC PAUSE : Press this button to enter recording
pause.
Press this button then press
3 to start
recording.
Note:
Refer also to the manual supplied with your VCR.
5 Try to operate your VCR by pressing
STANDBY/ON VCR.
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
Operating Other Manufacturers’ Video Equipment
6 Try to operate your CATV converter by pressing
STANDBY/ON TV/CATV.
When your CATV converter turns on or off, you have entered
the correct code.
If there are more than one code listed for your brand of
CATV converter, try each one until the correct one is entered.
Manufacturers’ codes for CATV converter
Manufacturer Codes
Echostar 01*
General Instrument 02, 03, 04, 05, 06,
07, 08, 09
Hamlin 16, 17, 18, 19
Pioneer 14, 15
RCA 20
Scient 10, 11
Sony 21
Zenith 12, 13
Manufacturers’ codes for VCR
* “01” is the initial setting.
* “01” is the initial setting.
Manufacturer Codes
JVC 01*, 02, 03
Emerson 10, 22
Gold Star 11
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05, 06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
EN30-42.RX-7520V[C]f.pm5 02.2.14, 4:33 PM 38