JVC RX-7520VBK - Manual (Page 42)

39
English
Manufacturer Codes
JVC 01*
Panasonic 02
Philips 04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
Manufacturers’ codes for DVD player
* “01” is the initial setting.
Manufacturers’ codes are subject to change
without notice. If they are changed, this remote
control cannot operate the equipment.
To change the transmittable signals for
operating a DVD player
1 Press and hold STANDBY/ON DVD.
2 Press DVD.
3 Enter manufacturer’s codes using buttons 1 – 9,
and 0.
4 Release STANDBY/ON DVD.
Now, you can use the following buttons on the DVD player.
STANDBY/ON DVD : Turn on or off the DVD player.
After pressing DVD (source selecting button), you can use the
following buttons on the DVD player:
3 : Start playback.
7 : Stop playback.
4 : Return to the beginning of the
current (or previous) chapter.
¢ : Skip to the beginning of the next
chapter.
8 : Pause playback. To release it, press 3.
DVD menu operations
After pressing DVD (source
selecting button), you can use the
following buttons for DVD menu
operations:
MENU : Display or erase the menu screen.
5 5 5 5 5/∞ ∞ ∞ ∞ ∞/3 3 3 3 3/2 2 2 2 2 : Select an item on the menu screen.
ENTER : Enter a selected item.
5 Try to operate your DVD player by pressing
STANDBY/ON DVD.
When your DVD player turns on or off, you have entered the
correct code.
If there are more than one code listed for your brand of DVD
player, try each one until the correct one is entered.
TEST
EFFECT
MENU
ENTER
CENTER
REAR L
SUBWOOFER
REAR R
1
4
7/P
10
2
5
8
0
3
6
9
10
100 RETURN
EN30-42.RX-7520V[C]f.pm5 02.2.14, 4:33 PM 39