How to use the set-up menu, Cont.), Set-up menu items – JVC TM-15L1D User Manual
Page 16
16
How to Use the SET-UP MENU
(cont.)
7
SET-UP MENU items
PICTURE SUB ADJ.
Sets the standard level for the picture adjustments by using the CHROMA/PHASE and CONTRAST/BRIGHT buttons
on the front panel.
CONTRAST*
Adjusts the standard level for contrast adjustment.
–20 - 00 - +20
BRIGHT*
Adjusts the standard level for brightness adjustment.
–20 - 00 - +20
CHROMA*
Adjusts the standard level for chroma adjustment.
–20 - 00 - +20
PHASE*
Adjusts the standard level for phase adjustment.
–20 - 00 - +20
reset
Restores the items in “PICTURE SUB ADJ.” to the factory settings.
* Memorized for each input.
COLOR TEMP.
Selects the color temperature and adjusts the drive level of each color (R/G/B).
COLOR TEMP.*
Selects the color temperature.
• When selecting “USER1” or “USER2,” adjust the R/G/B
drive level below.
HIGH (9300), LOW (6500),
USER1, USER2
R DRIVE
Adjusts the drive level of red.
–40 - 00 - +40
G DRIVE
Adjusts the drive level of green.
–40 - 00 - +40
B DRIVE
Adjusts the drive level of blue.
–40 - 00 - +40
* Memorized for each input.
SIZE/POSI. ADJ. (USER)
Adjusts the position and size of the picture. This item is available only when “SCAN SIZE” (
☞ page 8) is set to
“USER.”
H. SIZE*
Adjusts the horizontal picture size.
–40 - 00 - +40
H. POSI.*
Adjusts the horizontal picture position.
–40 - 00 - +40
V. SIZE (4:3)*
Adjusts the vertical picture size (for 4:3 aspect ratio).
–40 - 00 - +40
V. SIZE (16:9)*
Adjusts the vertical picture size (for 16:9 aspect ratio).
–40 - 00 - +40
V. POSI. (4:3)*
Adjusts the vertical picture position (for 4:3 aspect ratio).
–40 - 00 - +40
V. POSI. (16:9)*
Adjusts the vertical picture position (for 16:9 aspect ratio).
–40 - 00 - +40
* Memorized for each input.
REMOTE SETTING
Sets the MAKE/TRIGGER terminal. (
☞ page 18)
SYSTEM
Selects the external control system of the MAKE/TRIGGER
terminal.
MAKE (make contact
system), TRIG. (trigger
system)
PORT F3
Selects the input which is controlled by the 3rd pin terminal
of the MAKE/TRIGGER terminal.
VIDEO 1, VIDEO 2, COMPO.,
SDI 1, SDI 2
• You cannot assign the same
input to both “PORT F3” and
“PORT F4.”
PORT F4
Selects the input which is controlled by the 4th pin terminal
of the MAKE/TRIGGER terminal.
03_TM-15L1D-EN2.indd 16
03_TM-15L1D-EN2.indd 16
06.11.15 1:07:39 PM
06.11.15 1:07:39 PM