JVC TM-15L1D - Manual (Page 17)

17
ENGLISH
NO SYNC FUNCTION
Selects the screen status when no signal is being input.
NO SYNC DISPLAY Sets the screen status when no signal is being input. OFF, SUSPEND (suspend
mode), GRAY (gray screen)
DELAY TIME Sets the period until the screen status changes after
signals stop coming in. 5, 20, 60 (seconds, approx.)
TALLY SELECT
Selects the tally lamp color.
Setting value: GREEN, RED
NOTE:
• To control the tally lamp, use the MAKE/TRIGGER terminal. (
☞ page 18)
STATUS DISPLAY
Selects whether or not to display the status. ( ☞ page 9)
Setting value: ON, OFF
NOTE:
• While this item is set to “ON,” warning messages except “Control lock on!” do not appears.
CONTROL LOCK
Turns on (or off) the control lock function to disable the buttons on the front panel.
Setting value: ON, OFF
NOTE:
• The following operations are available while this function is activated:
– Turning on/off the monitor
– Displaying the SET-UP MENU (by pressing CHROMA/PHASE button while pressing the MENU button) and turning
“CONTROL LOCK” to “OFF”
– Operating the monitor by the external control
If you try other operations, “Control lock on!” appears on the screen.
HOUR METER X100h
Shows the total hours of use.
NOTE:
• The hour is shown in 100-hour unit.
• The hour is reset to “000” after the total hours of use have reached to “999.”
• Use time less than 1 hour is not accumulated.
03_TM-15L1D-EN2.indd 17 03_TM-15L1D-EN2.indd 17 06.11.15 1:07:40 PM 06.11.15 1:07:40 PM