JVC PD-35DX EN - Manual (Page 41)

39
Additional preparation
ENGLISH
PD-42/35DX(ASIA) / LCT1373-001A / English
„ Connecting devices to the OUT terminal
The signals of the images and sound you are currently
viewing with this TV are output through the OUT terminal.
By connecting a VCR to the OUT terminal, you can record
the currently shown image and sound to that VCR. To do
this, connect the VCR and OUT terminal following the
steps below.
1 Connect the VIDEO in the OUT terminals and
the VCR’s VIDEO IN (video input) terminal with
a video cable
2 Connect the AUDIO (L and R) in the OUT
terminals and the VCR’s AUDIO IN (audio L/R
input) terminals with an audio cable
• When you turn off the TV, the signals from the OUT
terminal are also turned off.
• No signal is output when VIDEO-4 is chosen.
„ Connecting headphones
Connect the headphones with a stereo mini-jack (of 3.5 mm
in diameter) to the headphone jack at the receiver.
• The headphone volume is adjusted with the
“HEADPHONE” menu (see page 29).
„ Connecting Speakers/Amplifier
See the Audio equipment connection diagram, then connect
the audio equipment you desire to the TV.
You can use external front speakers to listen to the TV
sound instead of the TV speakers.
Before connecting anything:
• Read the manuals provided with the amplifier and
speakers.
• Turn the TV and amplifier off.
• To prevent magnetism from the speakers adversely
affecting the TV screen, use magnetically-shielded
speakers for the front speakers.
• Note that connecting cables are not supplied.
• The output from the AUDIO OUT terminal is not
interrupted by headphone connection to the TV. You
cannot cut the sound from the front speaker even if you
connect a headphone to the TV.
• Adjust the volume of the external speakers with the
amplifier.
AUDIO
OUT
R
L
DEO-4)
VIDEO
Y
L R Back of the receiver
1 Amplifier
2 External speakers (Magnetic-shielded type)
PD-42&35DX_Eng.book Page 39 Tuesday, January 28, 2003 5:39 PM