John Deere Tractor 100 Series OMG X23532 J0 - Manual (Page 34)

Service Mower - 33
SERVICE MOWER
a.Remove spring locking pin (B), pull and hold mower engagement drive
cable out, lift up and remove from bracket (C).
b.Remove cable spring (D) from idler sheave bracket (E).
MX16568
5. Remove spring locking pins and washers (F) and disconnect rear draft
arm (G) and adjustable lift links (H) on each side.
MX10521Y
Picture Note: 107 cm (42 in.) mower deck shown.
6. Remove spring locking pin and washer (I) and front draft rod (J) from
mower deck bracket (K).
7. Remove mower drive belt from drive sheave (L).
8. Remove wood blocks from both sides and slide mower deck out from
under the machine.
9. When operating the machine without the mower deck:
• Remove front draft rod from machine and attach it to the mower deck.
• On 107 cm (42 in.) mower deck only: Push mower engagement drive
cable into clip (M) and hook end of cable spring with hardware (N) into
peg on left side of machine frame.
Installing Mower Deck
1. Park machine safely. (See Parking Safely in SAFETY section.)
2. Put attachment lift lever in the transport position.
3. Slide mower under machine.
4. Put wood blocks under each side of mower deck.
5. Put attachment lift lever in lowest position.
MX16568
6. Fasten rear draft arm (A) and adjustable lift link (B), on each side, with
washers and spring locking pins (C).
MX10521Y
Picture Note: 107 cm (42 in.) mower deck shown.
7. Install front draft rod (D) into mower deck bracket (E) and secure with
washer and spring locking pin (F) on the left side of bracket as shown.
c
CAUTION: Avoid injury! Mower lift arms can pinch fingers.
Lift arms are spring loaded and can snap back when deck is
removed.
Lock lift lever before pulling pin to remove mower deck.
G
F
F
H
J
K
I
L
IMPORTANT: Avoid damage! To prevent clutch damage, make
sure front draft rod is installed correctly. Secure rod with washer
and spring locking pin on the left side of mower deck bracket.
A
C
C
B
D
E
F