Names and functions of parts – JVC BR-HD50E User Manual
Page 14
E-10
NAMES AND FUNCTIONS OF PARTS
Front panel
1
Cassette loading slot/LED
• For loading a cassette into or unloading it
from the slot.
Insert a standard DV cassette or a mini DV
cassette. (XPage 37)
• When BR-HD50 is in the OPERATE OFF
state and a cassette is loaded, it changes to
the OPERATE ON state.
• With a cassette loaded, the LED lights up in
green.
When a cassette is being loaded or ejected,
the LED flashes.
2
[OPERATE] button/LED
• Press this button to turn on the power and BR-
HD50 becomes ready for operation.
(OPERATE ON)
Press this button again when BR-HD50 is
already on to turn off the power. (OPERATE OFF)
• OPERATE LED lights up as follows.
OPERATE ON : the green LED lights up
OPERATE OFF : the red LED lights up
VCR error
: the red LED blinks
Memo
z
If DC IN MODE in the SYSTEM [2/2] Menu
screen is set to “OPE ON”, and power is sup-
plied to the DC IN terminal on the rear panel,
power is turned on and the unit enters OPER-
ATE ON mode without pressing this button.
z
Even after the power is turned off with this but-
ton, BR-HD50 is live with a small amount of
electricity.
Therefore, if BR-HD50 is not to be used for a
long period of time, please remove the AC
adapter to save energy.
3
[EJECT] button
• Press this button to eject the cassette.
Memo
z
It takes about 6 seconds for the cassette to be
ejected.
z
The cassette can be ejected even when BR-
HD50 is in the OPERATE OFF mode. After the
eject action is completed, BR-HD50 returns to
the OPERATE OFF mode.
4
Operation buttons
[REC] button/LED
• Hold down this button and press the PLAY
button to start recording. During recording,
the red LED lights up.
• Hold down this button and press the
PAUSE button to pause recording.
• If this button is pressed during recording, an
index signal is recorded on the tape (when
INDEX WRITE in the SYSTEM [2/2] Menu
screen is set to ON).
• When this button is pressed in the STOP
mode, the time code generator value can
be checked while the button is being held
down. If TC DUPLI.: DV Menu is set to
AUTO, the time code, date and time of the
IEEE1394 terminal can be checked. (In DV
mode only)
2
1
3
4