Jenn-Air 730-0165 User Manual
Stainless steel natural gas grill
Advertising
Table of contents
Document Outline
- COVER PAGE UL.doc
- TABLE OF CONTENT.doc
- PAGE 1-2.doc
- PAGE 3.doc
- PAGE 4.doc
- PAGE 5.doc
- PAGE 6.doc
- PAGE 7.doc
- PAGE 8.doc
- PAGE 9-10.doc
- PAGE 11-12.doc
- WARNING
- The rotisserie motor is equipped with a plug and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug.
- Keep the rotisserie motor cord away from the heated surfaces of the grill. When not in use remove and store the motor in a dry location.
- PAGE 13.doc
- PAGE 14.doc
- PAGE 15-16.doc
- LIGHTING INSTRUCTIONS
- MATCH LIGHTING
- STAINLESS STEEL
- GRILL RACK
- GRILL BURNERS
- WARNING
- Failure to properly place the burner over the orifice could cause a fire to occur behind and beneath the valve panel, thereby damaging the grill and making it unsafe to operate.
- GRILL BURNER REMOVAL/INSTALLATION
- The grill burners are factory installed.
- To remove the main burners for cleaning:
- 1. Locate the cotter pin at the rear of the burner on the bottom side.
- 2. Remove the cotter pin and lift the burner out of the fire box.
- To reinstall the main burners:
- 3. Insert the burner over the valve assembly (Item# 11 on Page 18).
- 4. Insert the back of the burner into the hole at the rear of the fire box and reinsert the cotter pin.
- PAGE 17.doc
- PAGE 18.doc
- Page 19.doc
- PAGE 20-22.doc
- PAGE 23-24.doc
- PAGE 25.doc