John Lewis JLWM 1410 - Manual (Page 12)

4.4 Extra rinse symbol: it illuminates when
the option is enabled.
4.5 Cycle duration calculating symbol:
when selecting the «proportional»
programmes, the display shows the washing
duration of the maximum recommended
load. After the button 10 has been pressed,
on the display the «Wash time» (4.7) starts
blinking and the animated symbol appears to
indicate that the appliance is calculating the
laundry amount and the real duration.
During this time, the washing duration
shown decreases. When the calculating
phase has finished, the «Wash time» stops
blinking, the animated symbol disappears.
The washing time is adjusted to the real
load.
4.6 The following pieces of
information are shown on the display:
• Duration of washing programme in
hours and minutes, after you have
selected a programme. While the
programme is running (after you have
pressed the Start/Pause button), the
displayed time value decreases by one
unit every minute.
• Delay start, a time value indicated in
hours and minutes and selected by
pressing the delay start button. The delay
time (20 hours max) is displayed for a few
seconds, then the duration of the selected
programme reappears. After you have
pressed the button 10, the countdown is
updated every hour, and, for the last
hour, every minute.
• An alarm code indicates a fault with the
machine (see the relevant chapter).
• An incorrect option selection has
been made: this is indicated by the
message Err for a few seconds when an
option incompatible with the current
programme is selected.
• The washing machine has
completed the programme: this is
indicated by a flashing zero. The «Door
lock» pilot light (11) and the Start/Pause
light go out. The door can be opened.
• The washing machine has stopped
with water in the tub, at the end of
the «Soak» or of a programme with the
«Rinse hold» or «Quiet» option: this is
indicated by a flashing zero. The «Start/
Pause» light goes out but the «Door lock»
pilot light is still on. The door cannot be
opened.
4.7 «Wash time» message:
• on when the washing cycle starts and
when the duration is shown on the
display.
• off at the end of the cycle, and during the
delayed start selection
• blinking during the time calculation if you
have selected a «proportional»
programme.
4.8 Quick message: it appears when the
option is enabled.
4.9 Delay Startmessage: it appears during
the selection of the delay.
4.10 Child lock symbol (see more details
in the «Personalisation» chapter)
12