Jabra Pro 9450 - Manual (Page 29)

29
EN
G
LI
SH
JABRA PRO 9450
5. Gently pry the battery up and out of the headset. The battery will remain attached to the headset
by a pair of thin wires. Carefully disconnect the wires from the headset, and dispose of the old battery.
6. Align the wire connector of the new battery with the socket inside the headset, and press firmly into place.
If the new battery will not connect, check that the connector is not upside-down.
7. Fold the wires into the wire groove, and press the battery into place.
Ensure the battery´s label faces outwards.
8. Screw the speaker plate back onto the headset.
Q Why am I getting a buzzing sound in my headset?
A Assuming the device has been set up correctly, the phone may not be fully immune to the radio signals
the headset uses. To overcome this problem, move the headset base at least 30 cm away from the phone.
Alternatively, reduce the wireless range of your unit.
Q Why can’t I hear sound or listen to music from my PC in my headset?
A Check the following
• Ensure the Jabra PRO 9450 is set as the current audio device in the Windows sound control panel,
and in your softphone software.
• Ensure the audio link to your PC is active. Right-click the Jabra Device icon in the Windows taskbar,
and select Open Audio Link.
Q When I try to make a call on my desk phone, the Jabra GN1000 RHL lifts, but the call is not connected.
A Ensure the base is connected to the desk phone handset port, and not the desk phone headset port.
The Jabra GN1000 cannot be used in conjunction with a headset port.
Q Is it possible to automate calling and answering on my desk phone without using a handset lifter?
A Yes, if the desk phone has an electronic hook switch feature. Check your supplier for compatibility with your
phone, and/or consult the support area at www.jabra.com.
Q Is it possible to set up an automatic dial tone for my softphone when I undock my headset?
A Yes, the Jabra PRO 9450 can be configured to automatically get a dial tone on the target desk phone or
softphone when the headset is undocked. Automatic dial tones are configured independently for desk
phones and softphones. Desk phones are default-enabled, and softphones are default-disabled.
1. Launch Jabra Control Center, and select the ´Desk phone´ tab.
2. Select/deselect the ´Open link when headset is undocked´ setting, and then click Apply.
Q Why does my desk phone’s electronic hookswitch not work with my headset?
A Please check your specific desk phone documentation for compatibility and configuration settings.
Alternatively visit www.jabra.com/PRO9400