Jura Capresso F70 - Manual (Page 15)

15
Ⅲ Fill water into a container (approx. 1/2 litre) and immerse the
milk tube in it.
Ⅲ Place a sufficiently large vessel under the Professional-Cappuc-
cino Frother or the Easy-Cappuccino Frother.
Ⅲ Draw steam until the water from the Professional-Cappuccino
Frother or the Easy-Cappuccino Frother runs clean.
The Professional-Cappuccino Frother and the Easy-Cappuc-
cino Frother are best cleaned using the JURA Auto-Cappuc-
cino cleaner. Please contact an authorized dealer. We recom-
mend cleaning these devices daily.
14. Switching off the IMPRESSA
In order to ensure perfect operation, please don’t switch off
your IMPRESSA at the power switch (24) before all the
symbols on the display (9) have gone off except for
(3).
Ⅲ
READY
Ⅲ Switch off the IMPRESSA using the ON/OFF key
(3).
Ⅲ
RINSING
Ⅲ An automatic rinsing operation is started.
Ⅲ
Your IMPRESSA is in standby mode.
15. Programming
When your IMPRESSA leaves the factory it is adjusted such
that you can draw off coffee without having to change any
settings. However, you can programme various parameters
individually.
You can programme the following stages:
¼ Filter
¼ Water hardness
¼ Maintenance
¼ Aroma
¼ Temperature
¼ Time
¼ Automatic switch-on time
¼ Automatic switch-off time
¼ Draw-offs
¼ Language
¼ Display
¼ Exit
To start programming, press the Rotary Switch (1) until
FILTER – / ߛ appears
Rotary switch
Turn the Rotary Switch to change the adjusted values or to
select the next programming step.
Press the Rotary Switch to check the values adjusted or to
save the values selected (Fig. 17).
15.1 Programming the filter
Refer to Chapter 5.1 «Inserting the filter».
15.2 Programming the water hardness
Refer to Chapter 4 «Adjusting the water hardness».
15.3 Maintenance menu
Ⅲ READY
Ⅲ Press the Rotary Switch (1) until
FILTER – /
ߛ appears
Ⅲ The illuminated ring (2) is active.
Ⅲ Turn the Rotary Switch (1) until
MAINTENANCE appears
E