Jura Capresso F70 - Manual (Page 6)

6
Introduction
Thank you for purchasing the IMPRESSA. To ensure perfect func-
tioning of your IMPRESSA, carefully read this operating manual
and keep it for future reference.
Should you need more information or if you encounter particular
problems not specified in these operating instructions in sufficient
detail, either contact us directly or contact your local authorized
dealer.
You will also find useful tips on operation and maintenance
of your IMPRESSA on our website at www.jura.com.
1. Safety information
1.1 Warning
Ⅲ Children do not realize the dangers involved in using electric
appliances, for this reason always keep an eye on children when
they use electric appliances.
Ⅲ The coffee machine may only be used by instructed persons.
Ⅲ Never use a defective coffee machine or a machine with a
defective mains cable.
Ⅲ Never repair or open the coffee machine yourself. Any repairs
may only be carried out by authorized service shops using ori-
ginal spare parts and accessories.
Ⅲ Never immerse the coffee machine in water.
1.2 Precautions
Ⅲ Never expose the coffee machine to weather (rain, snow, frost),
never touch the machine when your hands are wet.
Ⅲ Place the IMPRESSA on a firm, level base that is resistant to
any water that may leak. Never stand on hot or warm surfaces
(oven hobs). Keep out of the reach of children.
Ⅲ If you don’t use the machine for a longer time (holidays, etc.)
always disconnect the mains cable.
Ⅲ Always disconnect mains cable before cleaning the machine.
Ⅲ When disconnecting the mains cable never pull on the mains
cable or the machine itself.
Ⅲ The coffee machine is connected to mains supply via a mains
cable. Make sure nobody can trip over the mains cable. Make
sure children and pets cannot reach the machine
Ⅲ Never put the coffee machine or individual parts of it into a
dishwasher.
Ⅲ Make sure to install the machine at a place with sufficient air
circulation, to prevent overheating of the machine.
2. Preparing the IMPRESSA
2.1 Check supply voltage
The IMPRESSA is preset in the factory to the correct mains
voltage. Check if your local mains supply voltage complies with
the information given on the type plate on the underside of the
IMPRESSA.
2.2 Check electrical fuse
The IMPRESSA is designed for an electric current of 10 amperes.
Check if the electrical fuse has sufficient capacity.
2.3 Fill water tank
Only use fresh, cold water. Never fill in milk, mineral water
or other liquids.
Ⅲ Remove the water tank and rinse it with cold tap water
thoroughly (Fig. 4).