JVC TK-C215V4 - Manual (Page 2)

2
Introduction
Information for Users on Disposal of Old Equipment
[European Union]
This symbol indicates that the electrical and electronic equipment should not be
disposed as general household waste at its end-of-life. Instead, the product
should be handed over to the applicable collection point for the recycling of
electrical and electronic equipment for proper treatment, recovery and recycling
in accordance with your national legislation.
By disposing of this product correctly, you will help to conserve natural resources
and will help prevent potential negative effects on the environment and human
health which could otherwise be caused by inappropriate waste handling of this
product. For more information about collection point and recycling of this product,
please contact your local municipal office, your household waste disposal service
or the shop where you purchased the product.
Penalties may be applicable for incorrect disposal of this waste, in accordance
with national legislation.
(Business users)
If you wish to dispose of this product, please visit our web page
www.jvceurope.com to obtain information about the take-back of the product.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in accordance with
applicable national legislation or other rules in your country for the treatment of
old electrical and electronic equipment.
Safety Precautions
Attention:
This symbol is
only valid in the
European Union.
FOR USA AND CANADA
The lightning flash with arrowhead
symbol, within an equilateral
triangle is intended to alert the user
to the presence of uninsulated
Adangerous voltageB within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
CAUTION:TO REDUCE THE RISK OF ELECTRIC
SHOCK. DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE.REFER
SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
Due to design modifications, data given in this
instruction book are subject to possible change
without prior notice.
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
AVERTISSEMENT:
POUR EVITER LES RISQUES
D'INCENDIE OU D'ELECTROCUTION,
NE PAS EXPOSER L'APPAREIL A
L'HUMIDITE OU A LA PLUIE.
INFORMATION (FOR CANADA)
RENSEIGNEMENT (POUR CANADA)
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numerique de la Class Best
conforme a la norme NMB-003 du Canada.
3
I
ⅷ The unit is to be powered by a DC 12 V or an
AC 24 V power supply.
ⅷ The unit is to be powered by a UL Listed DC
12 V or an AC 24 V power supply. (For U type)
ⅷ The AC 24 V and 12 V DC power supply shall
conform to the following: Class 2 only (For
USA), Isolated power supply only (For
Europe).
ⅷ This installation should be made by a qualified
service person and should conform to all local
codes.
ⅷ This installation shall be in accordance with
the National Electrical Code, ANSI/NFPA 70.
ⅷ Any Mention in this manual of Alarm inputs
have not been evaluated by UL to be used for
Burglar Alarm Functionality.
ⅷ Embedding of cameras in the ceiling may not
be allowed due to regulations in some
regions. Please consult your nearby
authorized JVC dealer for more details.
ⅷ The ceiling to mount the camera has to be
strong enough to support the weight of this
product. If the ceiling is not strong enough,
make sure to apply reinforcement to the
ceiling before installation.
ⅷ Be sure to tighten the screws and nuts
securely, Insufficient tightening may cause the
unit to fall from its mount.
ⅷ The rating label is displayed on the side of the
camera unit.
ⅷ The camera unit may fall if the mounting
screws and nuts are not properly tightened.
Ensure that the screws and nuts are properly
tightened.
ⅷ We do not accept liability for any damage to
the camera in cases when it is dropped
because of incomplete installation due to not
observing the installation instructions
correctly. Please be careful when installing the
camera.
ⅷ Do not install the camera near lighting
equipment with a high temperature, such as
spotlights. Doing so may cause malfunction or
fire.
INFORMATION FOR USA
Ⅵ INFORMATION
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the
equipment and receiver.
● Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/
TV technician for help.
Ⅵ CAUTION
CHANGES OR MODIFICATIONS NOT
APPROVED BY JVC COULD VOID USER'S
AUTHORITY TO OPERATE THE
EQUIPMENT.
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS
DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION. ⅷ Before starting an important recording, be
sure to perform a test recording in order to
confirm that a normal recording is possible.
ⅷ We will not provide any compensation
whatsoever for the contents to be recorded or
loss of opportunities when recording is not
properly performed due to malfunction of the
video camera, VTR, hard disk recorder or
video tape.
ⅷ Prior to adjusting the shooting direction of the
camera, touch the metal surface of the
[MONITOR] terminal with your hand to
discharge static electricity from your body.