JVC SR-VS10U - Manual (Page 31)

EN
31
Digital R 3
(VHS deck only)
Digital R 3 picture system applies edge correction to the luminance
signal to enhance detail.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS VHS MODE SET
SCREEN
2
Move the highlight bar
(arrow) to "VHS MODE
SET" by pressing CH
5∞ or
%fi, then press OK or #
.
SELECT DIGITAL R3 SET
MODE
3
Move the highlight bar
(arrow) to "DIGITAL R3" by
pressing CH
5∞ or %fi,
then press OK or
#
to set
to "ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
● Normally it is recommendable to keep "DIGITAL R3" set to
"ON".
● Depending on the type of tape being used, picture quality
may be better with "DIGITAL R3" set to "OFF".
● If you use this VCR as the player for editing, be sure to set
"DIGITAL R3" to "OFF" before starting.
MAIN MENU
MODE SET
=VHS MODE SET
DV MODE SET
TUNER SET
INITIAL SET
PRESS ( 5,∞), THEN (OK)
PRESS (MENU) TO END
VHS MODE SET
= S-VHS ET OFF
S-VHS MODE ON
VIDEO CALIBRATION ON
PICTURE CONTROL AUTO
DIGITAL TBC/NR ON
VIDEO STABILIZER OFF
NEXT PAGE
SELECT WITH ( 5,∞) AND (OK)
PRESS (MENU) TO END
PREVIOUS PAGE
=DIGITAL R3 ON
AUTO SP =EP TIMER OFF
SELECT WITH ( 5,∞) AND (OK)
PRESS (MENU) TO END
1 2 3
4 5 6
7 8 9
0
2
4
1
3
T W
DV VHS
CH
MENU
OK